- The key is not inserted in the ignition key cylinder
- Driver's door is OPEN (other doors are CLOSED)
- Driver's door is UNLOCKED

1. Insert the key into the ignition key cylinder, then remove it.

2. Within 40 seconds: Using the door control switch (for manual operation) move the switch 5 times to LOCK/UNLOCK at approximately 1 second intervals (so in this step, hit the lock button on the driver's door, then the unlock button a second later, and repeat 5 times)

3. Close the driver's door, then open it

4. Repeat step 2, again within 40 seconds

5. Insert the key into the ignition cylinder

6. Turn the ignition switch (the key) from ON to LOCK at approximately 1 second intervals for 1 - 5 times, depending on which mode..

Add mode - 1 time
Rewrite mode - 2 times
Confirmation mode - 3 times
Erase(Prohibition) mode - 5 times

7. Remove the key from the ignition key cylinder

8a. If add, rewrite, or erase mode have been selected:

The car should now lock and unlock the door itself, the number of times depending on which mode you selected. The number will be the same number you used to select the mode. So if you chose add, then the car will lock and unlock once, if you chose rewrite, then the car will lock and unlock twice...

8b. The car will lock/unlock itself at 2 second intervals for each set of code programmed into the car.

9. Press the transmitter switch for at least 1 second

10. The wireless door lock ECU automatically performs LOCK-UNLOCK once at a 1 second interval to inform the technician that it has received the signal from the transmitter

11. Close the driver's door, then open it.

12. Press the transmitter switch for at least 1 second

13. The car will LOCK-UNLOCK one or twice at 1 second intervals. If it LOCK-UNLOCK's once, then the it is completed. If it LOCK-UNLOCK's twice, then it has not been completed because the ECU didn't receive the same code from steps 9 and 12 or when selecting add mode, a recognition code indicating registration completed was already received.